Average Customer Rating: 
(6 reviews)
Add your own review for this product
Think twice (3/5), Feb 1, 2012
By Paul Matusky
(LHC AZ US)
Great idea but cheaply made. Still better than buying the real thing. The 1/4" pin is rough turned and tapered. Looks like somebody goofed and covered it up. Pin holder needs shimmed to align square to base and the FREE mirror template ain't much at all,just a rough piece of scrap.
Not sure if I will trust this company again.
Daisy Pin Router (4/5), Jan 22, 2012
By Bobby G. Johnson
(Murphy NC US)
Works great and I am very well pleased with the performance and safety. However, it would be nice to have some larger guide pins for use with larger bits. I suggest pins in 1/8 inch increments above 1/2 inch to about 1 1/2 inches.
Daisy Pin Router (3/5), Dec 19, 2011
By Tom Brockway
(Little Rock Ar US)
If you have a router table that mounts the router under the table (such as the Jess em table I have), the installation will go as shown on the instructions.
The instructions say to lower the pin into the collet. With the pin router's pin lowered, it stops about 7/8" above the table and the router is about 1/2" BELOW the table leaving a gap about 1-3/8".
I finally eyeballed it in using a 1/4" bit and the 1/4" pin. But was very disappointed that it was anywhere near as easy as led to believe.
The free mirro template that I received was poorly done. The edges were not smooth in a number of places making it unusable.
Once I got the pin router lined up, it did work fine. I made 9 cutting boards and the all turned out well.
Works well (4/5), Oct 20, 2010
By Wood is Good
(Las Vegas Ne US)
A little slop in the pin adjustment, but it's solid once you tighten the set screw. Wish that they would tap the arm so the pins could be stored/kept with the base.
Works well!
craftsman (5/5), May 17, 2010
By marty fair
(orange ca US)
I've been wanting to buy a pin router for my shop. But I can't afford 2000 dollars for a table-top model.
MLCS and daisy pin router you're the wood shop dream ...
I ordered my pin router cant wait to try it out on my table!! I'm sure it works as good as all your products .....Thank you for a great website.
Daisy Pin Router (5/5), Dec 18, 2009
By Paul
(Idaho Falls ID US)
This looked like the answer to a routing problem I was having. I was 100% correct. This setup works great and was easy to install.
There was one drawback...be it very small. The unit could be a bit taller giving more table clearance. I accomplished this need with a piece of 3/4" stock for a spacer between the table and mounting flange.
In operation, it is GREAT!!
Add your own review for this product
